© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
PMCM-9340D-0208 ACCESS 9340 and 9360 Meters
2/2008 Chapter 4—Metering Capabilities
EN–41
For each min/max value listed above, the following attributes are
recorded by the meter:
• Date/Time of minimum value
• Minimum value
• Phase of recorded minimum value
• Date/Time of maximum value
• Maximum value
• Phase of recorded maximum value
NOTE: Phase of recorded min/max only applies to multi-phase
quantities.
NOTE: There are a couple of ways to view the min/max values. The
meter display can be used to view the min/max values since the
meter was last reset. Using WinPM.Net, an instantaneous table with
the current month’s and previous month’s min/max values can be
viewed.
To Next Page