Siemens FC300 - Page 437

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.2.8.9 149 Transm. temp
above alarm limit
Transmitter temperature below
alarm limit
Standard:
● Process value
alarm
● Process value
warning
● Maintenance
alarm
● Maintenance
demanded
● Maintenance
required
● Function
check
● Process value
warning
● Maintenance
demanded
● Maintenance
required
● Function
check
Namur:
● Out of
specification
● Failure
● Maintenance
demanded
● Maintenance
required
● Function
Table B-34 Sensor
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.1.19.1 Type Sensor type. Also shown on the
device nameplate.
Read
only
3.1.19.2 Size Nominal sensor diameter (DN). Read
only
3.1.19.3 Order Number Replacement sensor order num‐
ber (MLFB). Also shown on the
device nameplate.
Read
only
Default settings
B.9 Maintenance and diagnostics
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 437