Siemens FC300 - Page 438

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.1.19.4 Serial Number Unique sensor serial number. Al‐
so shown on the device name‐
plate.
Read
only
3.1.19.5 Firmware Revision Firmware version of the sensor. Read
only
Table B-35 Maintenance
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.3.1 Copy configuration Copy configuration from the
SensorFlash to the device
User
3.3.2 Spare part replacement
3.3.2.1 Transmitter
3.3.2.1.1 Replace transmitter This will restore the data from
the transmitter on the transmitter
cassette module.
Expert
3.3.2.1.2 Replace transmitter cas‐
sette
This will restore the data from
the SensorFlash on the transmit‐
ter cassette module.
Expert
3.3.2.1.2 Replace sensor casette This will restore the data from
the SensorFlash on the sensor
cassette module.
Expert
3.3.8.4 HMI Hardware Revision HMI hardware version. Read
only
3.3.2.2 Sensor
3.3.2.2.1 Replace DSL This will restore the sensor-spe‐
cific data from the SensorFlash
on the sensor DSL module.
Expert
3.3.2.2.2 Replace sensor This will restore the sensor-spe‐
cific data from the SensorFlash
on the sensor
Expert
3.3.3 Operation time
3.3.3.1 Operating Time Total Total operating time of the trans‐
mitter since first power up.
Read
only
3.3.3.2 Operating Time Operating time of the transmitter
since last power up.
Read
only
Table B-36 Diagnostics
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.4.1 Sensor
3.4.1.1 Driver current The actual current value that ex‐
cites the sensor. High current:
check process conditions.
[A] Read
only
Default settings
B.9 Maintenance and diagnostics
MASS 2100 & FC300 (FCT030)
438 Operating Instructions, 06/2017, A5E39789040-AA