Siemens FC300 - Page 450

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.7.5.5.1 Register 1 Modbus register that specifies
the parameters to be logged.
Only parameters of type float,
and type unsigned with a maxi‐
mum size of 4 bates can be log‐
ged. 65535 = Register disabled.
3.7.5.5.2 Register 2 Modbus register that specifies
the parameters to be logged.
Only parameters of type float,
and type unsigned with a maxi‐
mum size of 4 bates can be log‐
ged. 65535 = Register disabled.
3.7.5.5.3 Register 3 Modbus register that specifies
the parameters to be logged.
Only parameters of type float,
and type unsigned with a maxi‐
mum size of 4 bates can be log‐
ged. 65535 = Register disabled.
-- --
-- --
-- --
3.7.5.5.90 Register 90 Modbus register that specifies
the parameters to be logged.
Only parameters of type float,
and type unsigned with a maxi‐
mum size of 4 bates can be log‐
ged. 65535 = Register disabled.
Table B-38 Simulation
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.8.1.1 Simulation inputs and outputs
3.8.1.1 Channel 1 – output with HART
3.8.1.1.1 Simulation Enable or disable simulation of
the current output.
Disabled
● Disabled
● Enabled
User
3.7.1.1.2 Simulation value Enter the current output value
for simulation.
4.00 mA
● 3.5 to 25.00
mA
User
3.8.1.2 Channel 2 - output
3.8.1.2.1 Operation mode Set the output functionality you
want the channel to operate.
Status output
● Current output
● Frequency
output
● Pulse output
● Status output
User
3.8.1.2.2 Simulation Enable or disable simulation of
the current output.
Disabled
● Disabled
● Enabled
User
Default settings
B.9 Maintenance and diagnostics
MASS 2100 & FC300 (FCT030)
450 Operating Instructions, 06/2017, A5E39789040-AA