Siemens M20 Terminal User Manual

Version 8 dated 15.03.00 223
Siemens Information and Communication Products
A
AT^SMGR Read SMS message without set to REC READ ..........................................119
AT^SMONC Cell Monitoring ............................................................................................136
AT^SMSO Switch off mobile station turn off ................................................................122
AT^SNFA Set or query of microphone attenuation .......................................................122
AT^SNFE Set or query echo parameters .......................................................................123
AT^SNFI Set microphone path parameters ..................................................................124
AT^SNFM Mute microphone .........................................................................................124
AT^SNFO Set or query of audio output (= loudspeaker path) parameters ....................125
AT^SNFS Select audio hardware set .............................................................................126
AT^SNFV Set or query loudspeaker volume .................................................................126
AT^SPBA Browse the phonebook alphabetically ...........................................................73
AT^SPBS Steps the selected phonebook alphabetically .................................................75
AT^SPIC Display PIN counter .....................................................................................126
AT^SPLM Read the PLMN list ......................................................................................126
AT^SPLR Read entry from the preferred operator list ..................................................127
AT^SPLW Write an entry to the preferred operator list .................................................128
AT^SPWC List password counter ..................................................................................129
AT^SPWD Change password for a lock (including Siemens-defined locks) .................130
AT^SRESET Software reset ...............................................................................................130
AT^SRTC Select, query or test ringing tone .................................................................131
AT^SSET Set some unsolicited result codes .................................................................134
ATA Answer a call ..................................................................................................30
ATD Mobile originated call to dial a number and call of supplementary services .30
ATD><mem><n> Originate call to phone number <n> in memory <mem> ..............................33
ATD><n> Originate call to phone number in current memory .......................................34
ATD><str> Originate call to phone number in memory with corresp. alphanum. field ...35
ATDI Mobile originated call to dialable ISDN number <n> ...................................36
ATDL Redial last telephone number used .................................................................37
ATDS Dial stored phone number in ME-phonebook ................................................38
ATE Enable command echo ...................................................................................38
ATH Disconnect existing connection .....................................................................38
ATI Display product identification information ....................................................39
ATO Switch from command mode to data mode ...................................................39
ATQ Set result code presentation mode ..................................................................39
ATS0 Set number of rings before automatically answering the call ........................40
ATS10 Set disconnect delay after indicating the absence of data carrier ..................42
ATS12 Set pause length for Hayes ESC sequence .....................................................42
ATS2 Set Hayes ESC character ................................................................................40
ATS3 Set command line termination character ........................................................40
ATS4 Set response formatting character ..................................................................41
ATS5 Set command line editing character ...............................................................41
ATS7 Set number of seconds to wait for connection completion ............................41
ATS8 Set number of seconds to wait when comma dial modifier ...........................41
ATV Set result code format mode ...........................................................................42
ATX Set CONNECT result code format and call monitoring ................................43
ATZ Set all current parameters to user defined profile ..........................................43

Siemens M20 Terminal Specifications

General

Brand	Siemens
Model	M20 Terminal
Category	Engine
Language	English