5.4.5 19" rack mounting - X-300EEC product group
The X-300EEC can be installed in a rack singly or as pairs.
● Mounting singly:
To do this, an X-300EEC device is secured to a plate and screwed into the 19" rack.
● Mounting as pairs:
Here, two X‑300EEC devices are fastened together with plates before installation in the
rack:
– 1 plate as middle section (6 screws)
– 2 plates on the outside (3 screws each)
You will find dimension drawings of the plates in section X-300EEC dimension drawings
(Page 231).
Figure 5-3 Rack mounting of two IE‑Switches X‑300EEC fastened togetherFigure at top: Rear of the switchesFigure at
bottom: View from below
Table 5-3 Legend for rack mounting of two IE‑Switches X‑300EEC fastened together
No. Name
1 Plate for side
2 Spring washer
3 Hexagonal nut
5 Side section (the side panel should be under slight tension)
7 IE Switch X‑300EEC
Installation
5.4 Installing a switch
SCALANCE X-300
Operating Instructions, 11/2019, A5E01113043-24 109
To Next Page
Loading...
