Siemens SCALANCE XB-200 - Syslog Client

Configuring with Web Based Management
5.4 The "System" menu
SCALANCE XB-200 Web Based Management
110 Configuration Manual, 04/2015, C79000-G8976-C360-02
5.4.13
Syslog Client
System event agent
Syslog according to RFC 3164 is used for transferring short, unencrypted text messages
over UDP in the IP network. This requires a Syslog server.
Requirements for sending log entries:
● The Syslog function is enabled on the device.
● The Syslog function is enabled for the relevant event.
● There is a Syslog server in your network that receives the log entries. (Since this is a
UDP connection, there is no acknowledgment to the sender)
● The IP address of the Syslog server is entered on the device.
Description
The page contains the following boxes:
●
Syslog Client
Enable or disable the Syslog function.
●
Server Address
Enter the IP address of the Syslog server.
This table contains the following columns
●
Select
Select the row you want to delete.
●
Server Address
Shows the IP address of the Syslog server.
●
Server Port
Enter the port of the Syslog server being used.