Configuring with Web Based Management
5.4 The "System" menu
SCALANCE XB-200 Web Based Management
124 Configuration Manual, 04/2015, C79000-G8976-C360-02
Port Diagnostics
5.4.19.1
With this page, each individual Ethernet port can run independent fault diagnostics on the
cable. This test is performed without needing to remove the cable, connect a cable tester
and install a loopback module at the other end. Short-circuits and cable breaks can be
localized to within a few meters.
Note
Please note that this test is permitted only when no data connection is established on the
port to b
e tested.
If, however, there is a data connection to the port to be tested, this is briefly interrupted.
-establishment of the connection can fail and then needs to be done manually.
The page contains the following boxes:
●
Select the required port from the drop-down list.
●
Activates error diagnostics. The result is shown in the table.
To Next Page
Loading...
