Configuring with Web Based Management
5.4 The "System" menu
SCALANCE XB-200 Web Based Management
92 Configuration Manual, 04/2015, C79000-G8976-C360-02
Follow the steps below to configure the IP address using the DHCP client ID:
1. Enable the "DHCP Client" option.
2. Select the DHCP mode "via DHCP Client ID" from the "DHCP Mode" drop-down list.
3. Enter a character string to identify the device in the enabled "DHCP Client ID" input box.
This is then evaluated by the DHCP server.
4. Select the "Client Configuration Request (Opt.66, 67)" option, if you want the DHCP client
to use options 66 and 67 to download and then enable a configuration file.
5. Click the "Set Values" button.
Note
If a configuration file is downloaded, this triggers a system restart. Make sure that the
option "Client Conf
iguration Request (Opt.66, 67)" is no longer set in this configuration
General
Configuration of SNMP
On this page, you make the basic settings for SNMP. Enable the check boxes according to
the function you want to use.
To Next Page
Loading...
