Siemens SCALANCE XB-200 - Faults

Configuring with Web Based Management
5.3 The "Information" menu
SCALANCE XB-200 Web Based Management
Configuration Manual, 04/2015, C79000-G8976-C360-02
51
"Next" button
Click this button to go to the next page.
"Prev" button
Click this button to go to the previous page.
Drop-down list for page change
From the drop-down list, select the page you want to go to.
5.3.6
Faults
Error status
This page displays any errors that occur. Errors of the "Cold/Warm Start" event can be
deleted following confirmation.
If there are no more unanswered error/fault messages, the fault LED goes off.
The time calculation always begins after the last system start. When the system is restarted,
a new entry with the type of restart is created in the fault memory.
Description of the displayed values
●
No. of Signaled Faults
Number of errors displayed since the last startup.
The table contains the following columns:
●
Fault Time
Shows the time the device has been running since the last restart when the described
fault occurred.
●
Fault Description
Display of the fault status for the device.
●
Clear Fault State
If the "Clear Fault State" button is enabled, you can delete the fault.