Siemens SCALANCE XB-200 - Packet Error

Configuring with Web Based Management
5.3 The "Information" menu
SCALANCE XB-200 Web Based Management
64 Configuration Manual, 04/2015, C79000-G8976-C360-02
5.3.8.4
Packet Error
Bad received frames
This page shows how many bad frames were received per port. You cannot configure
anything on this page.
The displayed values are transferred by RMON.
On the page "Layer 2 > RMON > Statistics", you can set the ports for which values will be
displayed.
Description of the displayed values
The table has the following columns:
●
Port
Shows the available ports. The port is made up of the module number and the port
number, for example port 0.1 is module 0, port 1.
●
Error types
The other columns after the port number contain the absolute numbers of the incoming
frames according to their error type.
In the columns of the table, a distinction is made according to the following error types:
– CRC
Packets whose content does not match the CRC checksum.
– Undersize
Packets with a length less than 64 bytes.
– Oversize
Packets discarded because they were too long.
– Fragments
Packets with a length less than 64 bytes and a bad CRC checksum.