Siemens SCALANCE XB-200 - Lldp

Configuring with Web Based Management
5.3 The "Information" menu
SCALANCE XB-200 Web Based Management
Configuration Manual, 04/2015, C79000-G8976-C360-02
67
Description
This table contains the following columns:
●
VLAN ID
Shows VLAN ID of the VLAN to which the MAC multicast address is assigned.
●
MAC Address
Shows the MAC multicast address that the device has learned or the user has
configured.
●
Status
Shows the status of each address entry. The following information is possible:
– static
The address was entered statically by the user. Static addresses are stored
permanently; in other words, they are not deleted when the aging time expires or
when the device is restarted. These must be deleted by the user.
– IGMP
The destination port for this address was obtained by IGMP configuration.
●
Port List
There is a column for each slot. Within a column, the multicast group to which the port
belongs is shown:
– M
(Member) Multicast frames are sent via this port.
– I
(IGMP) Member of the multicast group, registration was by an IGMP frame.
– –
Not a member of the multicast group. No multicast frames with the defined multicast
MAC address are sent via this port.
– F
(Forbidden) Not a member of the multicast group. Moreover, this address may not be
an address learned dynamically with IGMP.
5.3.11
LLDP
Status of the neighborhood table
This page shows the current content of the neighborhood table. This table stores the
information that the LLDP agent has received from connected devices.
You set the interfaces via which the LLDP agent receives or sends information in the
following section: "Layer 2 > LLDP".