Siemens SCALANCE XB-200 - Page 165

Configuring with Web Based Management
5.5 The "Layer 2" menu
SCALANCE XB-200 Web Based Management
Configuration Manual, 04/2015, C79000-G8976-C360-02
165
Description of the displayed values
Table 1 has the following columns:
●
1st column
Shows that the settings are valid for all ports of table 2.
●
Setting
Select the setting from the drop-down list. You have the following setting options:
– enabled
Blocking of unicast frames is enabled.
– disabled
Blocking of unicast frames is disabled.
– No Change
Table 2 remains unchanged.
●
Copy to Table
If you click the button, the setting is adopted for all ports of table 2.
Table 2 has the following columns:
●
Port
All available ports are listed in this column. Unavailable ports are not displayed.
Note
Ring redundancy / standby
If ring redundancy or standby is enabled, the ports configured for this are not included in
the unicast blocking.
●
Setting
Enable or disable the blocking of unicast frames.
Steps in configuration
Enabling blocking for an individual port
1. Select the check box in the relevant row in table 2.
2. To apply the changes, click the "Set Values" button.
Enabling blocking for all ports
1. In the "Setting" drop-down list, select the "enabled" entry.
2. Click the "Copy to Table" button. The check box is enabled for all ports in table 2.
3. To apply the changes, click the "Set Values" button.