Configuring with Web Based Management
5.5 The "Layer 2" menu
SCALANCE XB-200 Web Based Management
Configuration Manual, 04/2015, C79000-G8976-C360-02
167
Description of the displayed boxes
The page contains the following boxes:
●
If you click on this text box, a drop-down list is displayed. Here you can select the VLAN
ID of a new MAC address you want to configure.
●
Here you enter a new MAC multicast address you want to configure.
The table has the following columns:
●
Select the row you want to delete.
●
Here, the VLAN ID of the VLAN is displayed to which the MAC multicast address of this
row is assigned.
●
Here, the multicast address is displayed that the device has learned or the user has
configured.
●
Static
Shows the status of each address entry. The address was entered statically by the user.
Static addresses are stored permanently; in other words, they are not deleted when the
aging time expires or when the device is restarted. These must be deleted by the user.
●
There is a column for each slot. Within a column, the multicast group to which the port
belongs is shown. The following values are possible:
– M
(Member) Multicast frames are sent via this port.
– F
(Forbidden) Not a member of the multicast group. Moreover, this address may not be
an address learned dynamically with IGMP.
– I
(IGMP) Member of the multicast group, registration was by an IGMP frame. This value
is only dynamically assigned.
– –
Not a member of the multicast group. No multicast frames with the defined multicast
MAC address are sent via this port.
Steps in configuration
Creating a new entry
1. Select the required ID from the "VLAN ID" drop-down list.
2. Enter the MAC address in the "MAC Address" input box
3. Click the "Create" button. A new entry is generated in the table.
To Next Page
Loading...
