Siemens SCALANCE XB-200 - Page 178

Configuring with Web Based Management
5.6 The "Security" menu
SCALANCE XB-200 Web Based Management
178 Configuration Manual, 04/2015, C79000-G8976-C360-02
●
Primary server
Using the options in the drop-down list, specify whether or not this server is the primary
server. You can select one of the options "yes" or "no".
●
Status
With this check box, you can enable or disable the RADIUS server.
Note
You can configure a maximum of three servers on this page.
Steps in configuration
Entering a new server
1. Click the "Create" button. A new entry is generated in the table.
The following default values are entered in the table:
– Server IP address: 0.0.0.0
– Port number: 1812
– Maximum number of transmission retries: 3
– Primary server: No
2. In the relevant row, enter the following data in the input boxes:
– Server IP address
– Port number of the destination
– Secret access ID
– Repetition of the secret access ID
– Maximum number of transmission retries
– Primary server
3. Click the "Set Values" button.
Repeat this procedure for every server you want to enter.
Modifying servers
1. In the relevant row, enter the following data in the input boxes:
– IP address
– Port number of the destination
– Secret access ID
– Repetition of the secret access ID
– Maximum number of transmission retries
– Primary server
2. Click the "Set Values" button.
Repeat this procedure for every server whose entry you want to modify.