Siemens SCALANCE XB-200 - Page 182

Configuring with Web Based Management
5.6 The "Security" menu
SCALANCE XB-200 Web Based Management
182 Configuration Manual, 04/2015, C79000-G8976-C360-02
The page contains the following boxes:
●
Management ACL
Enable or disable access control to the management of the IE switch.
As default, the function is disabled.
Note
If the function is disable
d, there is unrestricted access to the management of the IE
switch. The configured access rules are only taken into account when the function is
enabled.
●
IP Address
Enter the IP address or network address to which the rule applies.
If you use the IP address 0.0.0.0, the settings apply to all IP addresses.
●
Subnet Mask
Enter the subnet mask.
The subnet mask 255.255.255.255 is for a specific IP address. If you want to allow a
subnet, for example a C subnet, enter 255.255.255.0. The subnet mask 0.0.0.0 applies to
all subnets.
The table has the following columns:
●
Select
Select the row you want to delete.
●
Rule Order
Shows the order in which the ACL rules are checked. As soon as a rule matches, it is
used. The following rules are ignored.
●
IP Address
Shows the IP address.
●
Subnet Mask
Shows the subnet mask.
●
VLANs Allowed
Enter the number of the VLAN in which the device is located. The station can only access
the device if it is located in this configured VLAN. If this input box remains empty, there is
no restriction relating to the VLANs.
●
SNMP
Specify whether the station (or the IP address) can access the device using the SNMP
protocol.
●
TELNET
Specify whether the station (or the IP address) can access the device using the TELNET
protocol.
●
HTTP
Specify whether the station (or the IP address) can access the device using the HTTP
protocol.
●
HTTPS
Specify whether the station (or the IP address) can access the device using the HTTPS
protocol.