Configuring with Web Based Management
5.2 Login
SCALANCE XB-200 Web Based Management
40 Configuration Manual, 04/2015, C79000-G8976-C360-02
There are two ways in which you can log in via HTTP. You either use the login option in the
center of the browser window or the login option in the upper left area of the browser
window.
The following steps apply when logging in whichever of the above options you choose:
1. Enter the following in the "Name" input box:
– "admin": With this user type, you can change the settings of the device (read and write
access to the configuration data).
– "user": With this user type, you cannot change any of the settings of the device (read
access to the configuration data).
2. Enter your password in the "Password" input box.
When you log in for the first time or following a "Restore Factory Defaults and Restart",
enter the standard password in the "Password" input box.
– "admin": standard password "admin"
– "user": standard password "user"
3. Click the "Login" button or confirm your entry with "Enter".
When you log in for the first time or following a "Restore Factory Defaults and Restart",
you will be prompted to change the password. You need to repeat the password as
confirmation. The password entries must match. Click the "Set Values" to complete the
action and activate the new password.
Once you have logged in successfully, the start page appears.
Web Based Management also allows you to connect to the device over the secure
connection of the HTTPS protocol. Follow these steps:
1. Click on the link "Switch to secure HTTP" on the login page or enter "https://" and the IP
address of the device in the address box of the Internet browser.
2. Confirm the displayed certificate warning.
The login page of Web Based Management appears.
3. Enter the following in the "Name" input box:
– "admin": With this user type, you can change the settings of the device (read and write
access to the configuration data).
– "user": With this user type, you cannot change any of the settings of the device (read
access to the configuration data).
4. Enter your password in the "Password" input box.
When you log in for the first time or following a "Restore Factory Defaults and Restart",
enter the standard password in the "Password" input box.
– "admin": standard password "admin"
– "user": standard password "user"
5. Click the "Login" button or confirm your entry with "Enter".
When you log in for the first time or following a "Restore Factory Defaults and Restart",
To Next Page
Loading...
