Configuring with Web Based Management
5.4 The "System" menu
SCALANCE XB-200 Web Based Management
80 Configuration Manual, 04/2015, C79000-G8976-C360-02
Steps in configuration
Uploading files using HTTP
1. Start the upload function by clicking one of the "Load" buttons.
A dialog for uploading a file opens.
2. Select the required file and confirm the upload.
The file is uploaded.
3. If a restart is necessary, a message to this effect will be output. Click the "OK" button and
a restart will follow. If you click the "Cancel" button, there is no device restart. The
changes only take effect after a restart.
Downloading files using HTTP
1. Start the download function by clicking one of the "Save" buttons.
2. Select a storage location and a name for the file.
3. Save the file.
The file is downloaded and saved.
Deleting files using HTTP
1. Start the delete function by clicking the one of the "Delete" buttons.
The file is deleted.
Reusing configuration data
If several devices are to receive the same configuration and the IP addresses are assigned
using DHCP, the effort for configuration can be reduced by saving and reading in the
configuration data.
Follow the steps below to reuse configuration data:
1. Save the configuration data of a configured device on your PC.
2. Load this configuration file on all other devices you want to configure in this way.
3. If individual settings are necessary for specific devices, these must be made online on the
relevant device.
Note
Configuration data has a checksum. If you edit the files, you can no longer upload them to
the IE switch.
To Next Page
Loading...
