3.5 PoE
3.5.1 The "show" commands
This section describes commands with which you display various settings.
3.5.1.1 show poe status
Description
This command shows specific information for all or for a selected PoE interface (PoE: Power
over Ethernet).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show poe status [interface <interface-type> <interface-id>]
The parameters have the following meaning:
Parameter Description Range of values / note
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
If you use the command without setting parameters, information about all PoE interfaces is
displayed.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The information for the selected PoE interface is displayed.
Configuration
3.5 PoE
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
110 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General