Result
The operating mode for the private VLAN port is configured.
Further notes
You display this setting and other information with the show vlan port config command.
You configure the interface as a switch port with the switchport command.
You configure a host port with the switchport private-vlan host-association
command.
You configure a promiscuous port with the switchport private-vlan mapping
command.
6.1.3.10 switchport priority default
Description
With this command, you configure the priority default for the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport priority default <(0-7)>
The parameter has the following meaning:
Parameter Description Range of values / note
- Value for the priority default 0 ... 7
Default: 0
Result
The setting for the default priority of the interface is configured.
Further notes
You reset the priority default to the original default with the no switchport priority
default command.
You display this setting and other information with the show vlan port config command.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
186 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
