Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global configuration
mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip dhcp relay information [vlan <vlan-id>]
The parameter has the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The configuration settings are displayed.
7.4.2 Commands in the Global Configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
7.4.2.1 ip dhcp server
Description
With this command, you specify the IP addresses of the DHCP servers to which the DHCP
relay agent forwards the frames. You can specify up to four IP addresses for the DHCP relay
agent.
Network protocols
7.4 DHCP Relay
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 309
To Next Page
Loading...
