The parameters have the following meaning:
Parameter Description Range of values / note
aa:aa:aa:aa:aa:aa MAC address of the interface -
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show dot1d mac-address-table static unicast command, you display the
list of configured entries.
With the mac-address-table static unicast command, you create an entry.
10.2.3 Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
10.2.3.1 switchport ingress-filter
Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Load control
10.2 Static MAC filtering
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 469
To Next Page
Loading...
Need help?
General