You can display the status of this function and other information with the show loopd
command.
12.6.2.2 no loopd
Description
With this command, you disable the loop detection function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no loopd
Result
The loop detection function is disabled
Further notes
You enable the function with the loopd command.
You can display the status of this function and other information with the show loopd
command.
12.6.2.3 loopd vlan mode
Description
With this command, you enable the loop detection function for VLAN.
Diagnostics
12.6 Loop detection
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 601
To Next Page
Loading...
Need help?
General