delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter Description Range of values / note
showfiles Shows the available files -
filetype Keyword for the file type to be deleted -
filetype Name of the file type max. 100 characters
Result
The files are displayed or the file is deleted.
Further notes
With the "show loadsave files" command, you can display the file types.
3.2.6.2 password
Description
With this command, you activate and configure the password for a file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
password {showfiles|filetype<filetype>[pw<password>]}
The parameters have the following meaning:
Parameter Description Values
showfiles Shows the available files -
filetype Shows that the file type follows that will be loaded -
filetype Name of the file type max. 100 characters
pw Keyword for the password -
password Password Enter the password for
the file.
Configuration
3.2 Load and Save
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
96 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General