7.4 DHCP Relay
This section describes commands for the DHCP Relay Agent.
7.4.1 The "show" commands
This section describes commands with which you display various settings.
7.4.1.1 show dhcp server
Description
With this command, you display the IP addresses of the DHCP servers to which the device
forwards the frames.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global Configuration
mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show dhcp server
Result
The IP addresses of the DHCP servers are displayed.
Further notes
With the "ip dhcp server" command, you specify the IP addresses.
7.4.1.2 show ip dhcp relay information
Description
This command displays the DHCP relay agent settings for all or for a selected VLAN.
Network protocols
7.4 DHCP Relay
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
308 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General