Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp relay common-agent-address
Result
The relay agent uses a common agent address in DHCP requests.
Further notes
You disable the use of a common agent address with the no ip dhcp relay common-
agent-address command.
You define a common agent address with the ip dhcp relay common-agent-address-
interface command.
You reset the common agent address to the default value with the no ip dhcp relay
common-agent-address-interface command.
7.4.2.7 no ip dhcp relay common-agent-address
Description
With this command, you disable the use of a common agent address. When the function is
disabled, the relay uses the address of the receiving port in DHCP requests.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay common-agent-address
Network protocols
7.4 DHCP Relay
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
314 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General