Siemens SCALANCE XC-200 - Switchport Acceptable-Frame-Type

Syntax
Call the command without parameter assignment:
no private-vlan mapping
Result
The IP interface of the primary PVLAN cannot be reached from the selected secondary
PVLANs.
Further notes
You configure a link between secondary PVLANs and the IP interface of the primary PVLAN
with the command private-vlan mapping.
You display this setting with the show interfaces command with the private-vlan
mapping parameter.
6.1.3.3 switchport acceptable-frame-type
Description
With this command, you configure which types of frames are accepted.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged|
untaggedAndPrioritytagged}
The parameters have the following meaning:
Parameter Description Range of values / note
all All frames are accepted. Default
On a ring port only the parameter
"all" is supported.
tagged The device discards all untagged
frames. The device forwards all tagged
frames.
-
untaggedAndPriori
tytagged
The device discards all tagged frames.
The device forwards all untagged
frames and frames with a priority.
-
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
180 Configuration Manual, 07/2017, C79000-G8976-C361-06