Further notes
You configure the duplex mode of the interface with the duplex command.
3.1.10.7 lldp
Description
With this command, you enable the sending and receipt of LLDP packets on the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
lldp{transmit|receive}
The parameters have the following meaning:
Parameter Description Range of values / note
transmit The sending of LLDP packets is ena‐
bled.
Default: enabled
receive The receipt of LLDP packets is enabled. Default: enabled
Note
Enabling both options
When you call this command, you can only select one option.
If you want to enable both options, call up the command again.
Result
Sending or receipt of LLDP packets is enabled.
Further notes
You disable the sending or receipt of LLDP packets with the no lldp command.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
80 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General