Result
The name is configured.
Further notes
You delete the name of the MST region with the no namecommand.
You display this setting and other information with the show spanning tree mst
configuration command.
6.3.6.4 no name
Description
With this command, you reset the name for the MST region to the default value.
The default value is:
● The MAC address of the device is configured as name.
Requirement
You are in the MSTP Configuration mode.
The command prompt is as follows:
cli(config-mst)#
Syntax
Call the command without parameters:
no name
Result
The name is reset to the default value.
Further notes
You configure the name of the MST region with the name command.
You display this setting and other information with the show spanning tree mst
configuration command.
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
262 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General