Result
The status of the optical ports is displayed.
12.2.2 Commands in the Interface Configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
12.2.2.1 fmp
Description
With this command, you enable fiber monitoring.
Requirement
● To be able to use the fiber monitoring function, enable LLDP. The fiber monitoring
information is appended to the LLDP packets.
● You can only use fiber monitoring with transceivers capable of diagnostics. Note the
documentation of the devices.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
fmp
Default: enabled
Result
Fiber monitoring is enabled.
Diagnostics
12.2 FMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 569
To Next Page
Loading...
Need help?
General