For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The static unicast MAC addresses are displayed.
8.5.3.3 show unicast-block config
Description
This command shows the unicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show unicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter Description Range of values / note
port Keyword for a port description -
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
For information on names of interfaces and addresses, refer to the section "Addresses and
interface names (Page 36)".
Result
The unicast blocking settings for ports are displayed.
8.5.4 Commands in the global configuration mode (Transparent Bridge)
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Layer 2 management protocols
8.5 Unicast
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 417
To Next Page
Loading...
