Siemens SCALANCE XC-200 - Spanning-Tree Bpdu-Receive; Spanning-Tree Bpdufilter

6.3.5.6 spanning-tree bpdu-receive
Description
With this command, you enable or disable the BPDU receive status at the port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdu-receive{enabled|disabled}
The parameters have the following meaning:
Parameter Description Range of values / note
enabled BPDU packets are received at the port Default: enabled
disabled BPDU packets are ignored at the port -
Result
The BPDU receive status is enabled or disabled.
Further notes
You can display the status of this function and other information with the show spanning-
tree interface command with the detail option.
6.3.5.7 spanning-tree bpdufilter
Description
With this command, you configure the BPDU transmit status for a port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 247