As default the function is "disabled".
Result
The port mirroring function is enabled.
Further notes
You can display the status of this function with the show monitorcommand.
You disable the function with the no monitor command.
12.5.2.2 no monitor
Description
With this command, you disable the port mirroring function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no monitor
Result
The port mirroring function is disabled.
Further notes
You can display the status of this function with the show monitorcommand.
You enable the function with the monitor command.
Diagnostics
12.5 Port Mirroring
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
590 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General