Syntax
Call the command without parameter assignment:
ip nat
Result
NAT is activated for the IP interface.
Further notes
You disable NAT for the selected IP interface with the no ip nat command.
You display the current configuration with the show ip nat summary command.
9.1.3.2 no ip nat
Description
With this command, you disable NAT for the selected IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ip nat
Result
NAT is deactivated for the selected IP interface.
Further notes
You enable NAT for the selected IP interface with the ip nat command.
You display the current configuration with the show ip nat summary command.
Layer 3 functions
9.1 NAT
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
440 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General