EasyManuals Logo

Siemens SCALANCE XC-200 Configuration Manual

Siemens SCALANCE XC-200
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #373 background imageLoading...
Page #373 background image
You can display the status of this function and other information with the show vlan device
info command.
8.1.2.3 gvrp
Description
With this command, you enable the GVRP function for all or individual interfaces on the device.
Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Syntax
Call the command without parameters:
gvrp
Result
In the Global configuration mode: The GVRP function is enabled on the device.
In the Interface configuration mode: The GVRP function is enabled for this interface.
Further notes
If you have enabled the GARP module, you start GVRP explicitly with this command.
If you want to disable the function for a specific interface on the device, use the no gvrp
command.
You can display the status of this function and other information with the show vlan device
info command.
8.1.2.4 no gvrp
Description
With this command, you disable the GVRP function for all or individual interfaces on the
device.
Layer 2 management protocols
8.1 GARP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 373

Table of Contents

Other manuals for Siemens SCALANCE XC-200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XC-200 and is the answer not in the manual?

Siemens SCALANCE XC-200 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XC-200
CategorySwitch
LanguageEnglish

Related product manuals