File type Description
Script Text file with CLI commands
You can upload a script file in a device. The CLI commands it contains are
executed appropriately.
StartupInfo Startup log file
This file contains the messages that were entered in the log during the last start‐
up.
Users This file contains the assignment of the user names to the corresponding pass‐
words.
3.2.2 The "show" commands
This section describes commands with which you display various settings.
3.2.2.1 show loadsave files
Description
This command shows the current Load&Save file information.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show loadsave files
Result
The current Load&Save file information is displayed.
3.2.2.2 show loadsave tftp
Description
This command shows the current configuration of the TFTP server for Load&Save.
Configuration
3.2 Load and Save
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 91
To Next Page
Loading...
Need help?
General