11.2.2.4 no radius-server
Description
With this command, you delete a RADIUS server entry on the client.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no radius-server ipv4 <ipv4-address> [primary]
The parameters have the following meaning:
Parameter Description Range of values / note
ipv4-address IPv4 Internet address of the Syslog
server
Format: 0.0.0.0
primary Identifies the RADIUS server as primary
server
-
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 36)".
Result
The entry for a connection between the RADIUS client and a server or the identification as
primary server is deleted.
Further notes
You configure the connection of a RADIUS client to a server with the radius-server
command.
You show the configuration of a RADIUS server on the client with the show radius
server command.
You show the statistical information of this function with the show radius statistics
command.
Security and authentication
11.2 RADIUS client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 511
To Next Page
Loading...
Need help?
General