Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x guest-vlan
Result
The guest VLAN function is disabled for a port.
Further notes
You enable the function with the dot1x guest-vlan command.
You display this setting and other information with the show dot1x command.
11.5.3.3 dot1x guest-vlan vlan-id
Description
With this command, you configure a guest VLAN for a port.
The port can only be assigned to the VLAN, if the VLAN has been created on the device.
Otherwise Authentication is rejected.
If during authentication a port is assigned to a VLAN dynamically using this function,
assignment using the VLAN-ID or the VLAN name is possible. Configure the following values
on the RADIUS server:
● Tunnel-Type = VLAN
● Tunnel-Medium-Type = IEEE-802
● Tunnel-Private-Group-Id = VLAN-ID or VLAN-Name
The IE switch distinguishes as follows:
● VLAN ID: The RADIUS server transfers a numeric string for the parameter "Tunnel-Private-
Group-Id".
● VLAN-Name: The RADIUS server transfers an alphanumeric string for the parameter
"Tunnel-Private-Group-Id".
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
530 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General