Result
The password for the file is configured and activated.
Further notes
You disable the password with the no password command.
3.2.6.3 no password
Description
With this command, you disable the password for a file.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
no password {showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter Description Values
showfiles Shows the available files -
filetype Shows that the file type follows that will be loaded -
filetype Name of the file type max. 100 characters
Result
The password for the file is disabled.
Further notes
You enable the password for the user certificate with the password command.
3.2.6.4 tftp filename
Description
With this command, you assign a name to a file type.
Configuration
3.2 Load and Save
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 97
To Next Page
Loading...
Need help?
General