The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no spanning-tree{forward-time|hello-time|max-age}
The parameters have the following meaning:
Parameter Description
forward-time Time after which a port changes its spanning tree status from "Blocking" to
"Forwarding"
hello-time Time after which the bridge sends its configuration frames (BPDUs)
max-age Time after which the information of the BPDUs becomes invalid
Result
The selected setting for the time is reset to the default value.
Further notes
You configure the time with the spanning-tree command (time settings).
You display these settings and other information with the commands that start with show
spanning-tree ....
6.3.5 Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 241
To Next Page
Loading...
Need help?
General