The parameters have the following meaning:
Parameter Description Range of values
ucast_addr Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The SNTP unicast server is reset to the default value.
Further notes
You configure the setting with the sntp unicast-server ipv4 command.
You display this setting and other information with the show sntp unicast–mode
status command.
System time
5.3 SNTP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
160 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General