The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ports
(
[<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[port-channel<a,b,c-d>]
[all]
)
[
untagged<interface-type> <0/a-b,0/c,...>
(
[<interface-type><0/a-b,0/c,...>]
[port-channel <a,b,c-d>]
[all]
)
]
[
(
forbidden<interface-type><0/a-b,0/c,...>
[<interface-type><0/a-b,0/c,...>]
[portchannel<a,b,c-d>]
[all]
)
]
[name<vlan-name>]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type of interface Enter a valid interface.
/a-b,0/c,... Port no. of the interface
port-channel Keyword for a port channel -
a,b,c-d Port no. of the interface Enter a valid interface.
untagged Keyword for interfaces or ports that transfer data packets without
VLAN marking
-
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
196 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General