Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call up the command with the following parameters:
cos-map <cos(0-7)> queue <queue(1-4)>
The parameters have the following meaning:
Parameter Description Range of values / note
cos Priority 0 … 7
Default: 1
queue Keyword for a queue -
queue Queue to which this priority is assigned 1 … 4
Default: 2
The CoS priorities are assigned to the queues as follows in the default setting:
● COS 0 → Queue 2
● COS 1 → Queue 1
● COS 2 → Queue 1
● COS 3 → Queue 2
● COS 4 → Queue 3
● COS 5 → Queue 3
● COS 6 → Queue 4
● COS 7 → Queue 4
Result
The assignment table for service classes is configured.
Further notes
You display the current assignment table of CoS priorities to queues with the show qos cos-
map command.
Load control
10.5 Service classes
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
488 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General