Siemens SIMATIC ET 200eco PN - Page 150

I/O device digital inputs/digital outputs
9.3 I/O device digital inputs/digital outputs
ET 200eco PN
150 Operating Instructions, 08/2016, A5E01250250-AJ
Technical data of the 8 DIO DC 24V/1,3A 8×M12 I/O device
Technical data
Dimensions and weight
Dimensions W x H x D (mm) 60 x 175 x 49
Weight
Approx. 910 g
Module-specific data
Transmission rate
100 Mbps full duplex
Transmission mode
100BASE-TX
Autonegotiation
Yes
Bus protocol PROFINET IO
• IRT with the option "high flexibility"
• IRT with the option "high performance"
Supported Ethernet services PROFINET IO (Device)
• ping
• arp
• LLDP
• Network diagnostics (SNMP)
• DCP
• Prioritized startup
• Media redundancy
PROFINET interface
• Connection socket
2 x M12 d-coded
• Switch function
Yes, internal
• Auto-crossover
Yes, if autonegotiation is enabled
Manufacturer ID (Vendor ID)
002A
H
Device ID (DeviceID)
0306
H
Voltages and currents
Supply voltage 1L+
DC 24 V
• Reverse polarity protection
Yes, against destruction, loads are activated
• Infeed current 1L+
Max. 4 A
Supply voltage 2L+
DC 24 V
• Reverse polarity protection
Yes, against destruction, loads are activated
• Infeed current 2L+
Max. 4 A
Current consumption
From supply voltage (1L+)
Typ. 100 mA (no digital output activated)
From supply voltage (2L+)
Typ. 5 mA (no digital output activated)
Power loss of the device type 4.5 W (if all channels are set as digital input)
type 6.5 W (if all channels are set as digital out-
put)