Siemens SIMATIC ET 200eco PN - Page 152

I/O device digital inputs/digital outputs
9.3 I/O device digital inputs/digital outputs
ET 200eco PN
152 Operating Instructions, 08/2016, A5E01250250-AJ
Technical data
Sensor supply
Number of sensor supplies 8, 4×1L+ and 4×2L+
Note: The sensor supply is only available when
the corresponding channel is parameterized as
an "Input".
Load current
100 mA per output
Short-circuit protection Yes, electronic
Sensor selection data
Cable length, shielded
Max. 30 m
Cable length, unshielded
Max. 30 m
Input voltage
• Nominal value
24 V DC
• For signal "1"
11 to 30 V
• For signal "0"
-3 to +5 V
Input current
• At signal "1"
Typ. 7 mA
Input delay
• At "0" to "1"
Typ. 3 ms
• At "1" to "0"
Typ. 3 ms
Input characteristic
According to IEC 61131, Type 3
Connection of 2-wire proximity switches
Supported
• Permitted quiescent current
Max. 1.5 mA
Actuator selection data
Cable length, shielded
Max. 30 m
Cable length, unshielded
Max. 30 m
Output voltage
• Nominal value
24 V DC
• For signal "1"
Min. 1L+/2L+ (-0.8 V)
Output current
• At signal "1"
Max. 1.3 A
• For "0" signal (residual current)
Max. 1.5 mA
Load resistance range
22 Ω to 3.3 kΩ
Lamp load
Max. 5 W
Parallel wiring of two outputs
• To increase performance
No
• For redundant control of a load
Supported
Control of a digital input
Yes