Siemens SIMOCODE DP

Display Remark Message Caused by
Good - -
Message is locked - -
5.3 Maintenance State and Maintenance Job
Messages
Messages for an incoming Signaling, Warning and Tripping event can be found using:
Tool Dialog
For PDM-Menu Device > Faults/ Warnings/ Status Information - You will 󹪝nd following tabs
according to the event:
• Device details
• Maintenance state
• Diagnostic view
– Status
– Errors
– Warnings
For WinCC You will 󹪝nd following tabs according to the event:
• Alarm Logging
• Warnings
• Faults
Correlation Maintenance Status and Maintenance Job
The following table provides an overview:
Meaning Maintenance job Status maintenance job
Maintenance required has been requested,
maintenance engineer has not yet created a
maintenance job
Maintenance demanded has been requested,
maintenance engineer has not yet created a
maintenance job
Maintenance alarm has been requested,
maintenance engineer has not yet created a
maintenance job
Maintenance Station
5.3Maintenance State and Maintenance Job
SIMOCODE DP PCS 7 Library Migration (Legacy) - V9.1 SP2
Programming and Operating Manual, 11/2022, A5E51265657002A/RS-AC/003 83