To Next Page

To Previous Page

Bit Meaning Con󹪝guration in PDM / WinSIMOCODE-DP

0.6 SIMORESET; L_SIMORESET Standard function blocks - Reset1 -> [062] DP Bit 0.6 Receive

0.7 Always output by the block

as TRUE

Fault response -> PLC-CPU Signal -> [063] DP Bit 0.7 Receive

1.0

1.7

I1_0

I1_7

user-speci󹪝c assignment

2.0 - 3.7 I23 user-speci󹪝c assignment

Refer INBT2 assignment. (Page56)

4.4.4 SIMO_STAT Status Display

SIMO_STAT is used to actuate the status display:

• Low Byte: identi󹪝er for the respective device state (see: Actuation of Status Display)

• 　 High Byte: identi󹪝er for SIMOCODE Function

– 16#00: OVL

– 16#08: SOFT

– 16#10: DIR

– 16#20: REV

– 16#30: STAR

– 16#40: DAHL

– 16#50: POL

– 16#60: VALVE

– 16#70: POS

4.4.5 VSTATUS and VSTATUS1 Status Display

The most important statuses and enable signals are passed through VSTATUS and VSTATUS1.

VSTATUS Bit_31:=QCSF; VSTATUS Bit_15:=LOCK;

VSTATUS Bit_30:=QOFF; VSTATUS Bit_14:=LOCK_ON;

VSTATUS Bit_29:=QON2; VSTATUS Bit_13:=LOCK_OPT;

VSTATUS Bit_28:=QON1; VSTATUS Bit_12:=VL_OPEN;

VSTATUS Bit_27:=QCUR; VSTATUS Bit_11:=VL_CLOSE;

VSTATUS Bit_26:=QG_FLT; VSTATUS Bit_10:=VL_HOLD;

VSTATUS Bit_25:=QG_WRN; VSTATUS Bit_09:=SS_POS;

VSTATUS Bit_24:=Q1_2; VSTATUS Bit_08:=QCTA;

VSTATUS Bit_23:=Q1_3; VSTATUS Bit_07:=QLTA;

SIMO_CHN Function

4.4Description of Parameters

SIMOCODE DP PCS 7 Library Migration (Legacy) - V9.1 SP2

58 Programming and Operating Manual, 11/2022, A5E51265657002A/RS-AC/003

Siemens SIMOCODE DP User Manual

Questions and Answers: