SIMPRO-100
SIMPRO-PC Software
3
PRIM-2400C 39
3 SIMPRO-PC Software
3.1 Introduction
The SIMPRO-PC software package is provided
with each SIMPRO-100 Relay. This software
package allows you to do the following:
• Create settings for one or more SIMPRO-100
Relays.
• Store and retrieve settings to and from PC
files.
• Upload and download relay settings to and
from SIMPRO-100 Relays.
• Execute relay serial port commands in
terminal mode to view relay and motor data.
3.2 System
Requirements
To successfully install and use the SIMPRO-PC
software, your PC must have the minimum
resources listed below:
Table 3.1 SIMPRO-PC Software System
Requirements
3.3 Installation
To install the SIMPRO-PC software, perform the
following steps:
1. With your PC turned on and all applications
closed, load the SIMPRO-PC software
CD-ROM into your CD-ROM drive.
2. The setup software should run automatically.
If Setup does not start, use the Microsoft
Windows Run function to start the program
Setup.exe from the CD-ROM.
3. Follow the steps as they appear on screen.
The setup program also gives you the
opportunity to install an online copy of the
SIMPRO-100 Relay Instruction Manual and
Adobe Acrobat Reader™ software necessary
to view the PDF format instruction manual.
Processor Pentium Class, ≥ 90 MHz
RAM ≥ 16 MB
Hard Drive 10 MB available space
Operating System Microsoft Windows
®
95/98 or NT 4.0
Serial Port One EIA-232 serial port (needed for
upload/download connection to
relay)
Drives 3.5" floppy or CD-ROM for software
installation
To Next Page
Loading...
