Siemens SIMPRO-100 - Introduction & Specifications Overview

SIMPRO-100
Introduction & Specifications
1
PRIM-2400C 19
1 Introduction & Specifications
1.1 Introduction
The SIMPRO-100 Motor Protection Relay is
designed to protect three-phase, medium voltage
motors. The basic relay provides locked rotor,
overload, unbalance, and short-circuit protection
functions. You can select options that add
voltage-based and RTD-based protection and
monitoring capabilities. All relay models offer
innovative monitoring functions, such as:
• Motor Start Reports and Motor Start Trend
Data
• Load Profiling
• Motor Operating Statistics
• Event Reports and Summaries and a
Sequential Events Record (SER)
• Complete Suite of Accurate Metering
Functions
This manual contains the information you need to
select, install, set, test, operate, and maintain any
SIMPRO-100 Relay. You probably will not need to
review the whole book to perform the specific
tasks that are your responsibility. The following is
an overview of the Chapters in this instruction
manual:
Chapter 1, "Introduction & Specifications"
page 19
Describes how to locate information in this
instruction manual; describes the basic
features and functions of the SIMPRO-100
Relay; shows how to create a SIMPRO-100
Relay part number; lists the SIMPRO-100
Relay specifications.
Chapter 2, "Installation" page 27
Describes how to mount and wire the
SIMPRO-100 Relay; illustrates wiring
connections for various applications.
Chapter 3, "SIMPRO-PC Software" page 39
Describes setup, features, and use of the
SIMPRO-PC software.
Chapter 4, "Settings Calculation" page 41
Describes how to calculate and record
settings for basic motor protection,
RTD-based protection functions, and
voltage-based functions.
Chapter 5, "Front-Panel Operation" page 75
Explains the features and use of the
SIMPRO-100 Relay front panel, including
front-panel command menu, default displays,
and automatic messages.
Chapter 6, "ASCII Serial Port Operation"
page 85
Describes how to connect the SIMPRO-100
Relay to a PC for communication; shows
serial port connector pinouts; lists and defines
serial port commands.
Chapter 7, "Commissioning" page 99
Describes the relay commissioning
procedure; provides protection element test
procedures.
Chapter 8, "Metering & Monitoring" page 111
Describes the operation of metering
functions, load profiling function, motor
operating statistics function, motor start
reports, and motor start trending function.
Chapter 9, "Event Analysis" page 117
Describes front-panel target LED operation,
trip-type front-panel messages, event
summary data, standard 15-cycle event
reports, and Sequential Events Recorder
(SER) report.
Chapter 10, "Maintenance & Troubleshooting"
page 127
Describes relay self-test alarms, relay
troubleshooting, and power supply fuse
replacement; provides firmware upgrade
instructions.