Siemens SINAMICS S120 - Page 216

Cabinet Modules
5.6 Motor Modules in chassis format
Cabinet Modules NEMA
216 Manual, 04/2014, A5E03586450A
Configuration
Motor Modules contain the following components as standard:
● Retaining device for the DC busbar, including the interface to the DC connections of the
Motor Module (the necessary DC busbar must be provided separately as option M80 to
M87).
● Connection busbar, nickel-plated, for motor cables for Motor Modules with frame sizes FX
and GX; for Motor Modules with frame sizes HX and JX, the motor cables are connected
directly to the device.
● Cable propping bar for the electric power cables
● DRIVE-CLiQ interface (3 DRIVE-CLiQ sockets), without Control Unit
● Customer interface -X55
● 6-pin auxiliary voltage supply, including auxiliary power module and cables for looping
through to the next Cabinet Module
● PE busbar (60 x 10 mm), including jumper for looping through to the next Cabinet
Module.
● EMC-compliant design thanks to additional shielding measures and appropriate routing of
cables.
Note
Additional information
The configuration examples of the individual Motor Modules are used to illustrate the
positioning of the factory
-fitted components. They show the maximum possible configuration
of the modules, which contain all options that can be ordered.
Refer to the layout diagrams (AO) on the customer DVD for the precise order
-specific
positioning of the components.